-
September 9th, 2005, 04:19 AM
#1
Inactive Member
i just got the clutch broke in and i've gotten on it about 5-6 times since then. noticed ALOT of white smoke on some full throttle runs and heres where im at now. pulled the plugs and they are white! from what i understand thats lean, right? and the compression results are as follows:
#1-147
#2-172
#3-195
#4-185
and heres a pic of the plug.

what do you guys think?
-
September 9th, 2005, 06:42 PM
#2
Inactive Member
Has the car been tuned? What are you running for engine management?
John
-
September 9th, 2005, 08:53 PM
#3
Inactive Member
yup, jim tuned it a few months back. gonna try and get a leak down test in the next few days.
-
September 10th, 2005, 08:52 AM
#4
Inactive Member
holy moly. that is some horrible compression results on an itr [img]graemlins/cry_smile.gif[/img]
good luck.
-
September 13th, 2005, 08:28 AM
#5
Inactive Member
looks very lean... turn up your fuel pressure
-
September 15th, 2005, 11:08 PM
#6
Inactive Member
Which cylinder did that plug come out of or do all of them look like that?
-
September 17th, 2005, 08:20 PM
#7
Inactive Member
JRCIVIC,
What should be the PSI on a fresh type R be?
-
September 18th, 2005, 03:54 AM
#8
Senior Hostboard Member
Although the insulator does look a bit on the light side, I find the chalk on the base of the ground strap more disturbing. This residue would indicate foreign intrusion... such as oil or coolant. Since your compression numbers are low, chances are good that it is oil. Burning oil reduces the combustion processes efficiency... thus requiring more fuel to compensate. This would be the reason the insulator is not that "caramel or light tan" color.
Is the car consuming any coolant ???
I ask because you mentioned that the car smokes WHITE while driving... which would indicate that you are burning coolant. However, if in fact the color is more of a BLUE/GREY, this is consistant with the buring of oil in the combustion cycle.
-
October 20th, 2005, 02:07 AM
#9
Senior Hostboard Member
Many things to check:
1) The O-ring seal around the oil seperator box.
2) The 90' hose coming from the block going into the top of the oil seperator box.
3) The O-ring seal behind the oil cooler plate.
4) The oil filter.
5) The PCV valve and/or the hose leading from it to the bottom of the blower inlet neck just ahead of the throttle-body side of the blower itself.
-
October 20th, 2005, 02:25 AM
#10
Inactive Member
im gonna have some fun this weekend!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks